How to find the boot disk from HP-UX operating system

In this article , I would explain to you how we find which disk are used to boot the running HP-UX operating system. This is a bit tricky because its depending on the version of HP-UX, and whether it is using LVM or the less common choice.

For LVM disk layouts:

For 11.11 and earlier, use the below command to check which disk is in used.

hpx:/> echo “boot_string/S” | adb -k /stand/vmunix /dev/kmem

    boot_string:

    boot_string:    disk(0/0/2/0.6.0.0.0.0.0;0)/stand/vmunix

For 11.23, there are different ways for PARISC versus IA64:

PARISC:

hpx:/> echo “boot_string/S” | adb -o /stand/vmunix /dev/kmem

    boot_string:

    boot_string:    disk(1/0/0/3/0.6.0.0.0.0.0;0)/stand/vmunix

IA64 (Itanium/Integrity):

hpx:/> echo “bootdev/x” | adb -n /stand/vmunix /dev/kmem

    bootdev:

        0x100001c

Now to find the actual path, you’ll have to match the 0x100001c value to a minor number in the /dev/disk directory. Compare only the last 6 digits of the number (00001c) to find the device file. Then by using lssf, you can decode the hardware path:

    hpx:/> DSK=$(ll /dev/disk | awk ‘/00001c/{print $NF}’)

    hpx:/> echo $DSK

    disk11_p2

    hpx:/> HWPATH=$(lssf /dev/disk/$DSK | awk ‘{print $(NF-1)}’)

    hpx:/> echo “$DSK path = $HWPATH”

    disk11_p2 path = 64000/0xfa00/0xa

You can also use ioscan -m dsf to map agile device file names to legacy (CTD) style.

For VxVM disk layouts:

hpx:/> echo “raw_root/X” | adb -o /stand/vmunix /dev/kmem

     raw_root:

     raw_root:       0x3000002

This value is the minor number for the disk that was used to boot the current system. The minor number is found in the /dev/vx/dmp directory.

     hpx:/> DSK=$(ll /dev/vx/dmp | awk ‘/000002/{print $NF}’)

     hpx:/> echo $DSK

    c2t1d0s2

     hpx:/> HWPATH=$(lssf /dev/dsk/$DSK | awk ‘{print $(NF-1)}’)

     hpx:/> echo “$DSK path = $HWPATH”

     c2t1d0s2 path = 0/1/1/0.1.0

For completeness, I should mention that 11.31 will report the boot disk path in syslog.log (LVM or VxVM) like this:

vmunix: Boot device’s HP-UX HW path is: 0/1/1/0.0×1.0x0

However, syslog.log is a catch-all for a lot of items and often needs to be truncated when it grows too large. As a result, it can’t be relied on to always contain the current boot disk.